I know it's been mentioned on the forums before, but I don't know where and I don't care to look.
I want to swim a USA-S meet but I want the times to count for USMS, how do I go about doing that at the meet?
Thanks!
Chris, I'm hoping you or someone else who knows, can answer this, this is my meet entry www.pvswim.org/.../10-64ma1.htm It says the pool has not met USA-S standards for pool measurement for their rule
Dimensional Tolerance: Against the required length, a tolerance of plus (+) 0.03 meters (1 and 3/16ths of an inch) in a vertical plane extending 0.3 meters (12 inches) above and 0.8 meters (2 feet, 7 and 1/2 inches) below the surface of the water at all points of both end walls.
Should I even bother to ask for USMS measuring or just use this as a warm up for my USMS LCM meet coming up?
The entry info says that it hasn't been certified. I don't know whether this is because the pool is too short, or if they just haven't bothered.
Jeff Roddin (the PV Top Ten Recorder) might know: you could ask him. You could also contact the meed director for more info.
Chris, I'm hoping you or someone else who knows, can answer this, this is my meet entry www.pvswim.org/.../10-64ma1.htm It says the pool has not met USA-S standards for pool measurement for their rule
Dimensional Tolerance: Against the required length, a tolerance of plus (+) 0.03 meters (1 and 3/16ths of an inch) in a vertical plane extending 0.3 meters (12 inches) above and 0.8 meters (2 feet, 7 and 1/2 inches) below the surface of the water at all points of both end walls.
Should I even bother to ask for USMS measuring or just use this as a warm up for my USMS LCM meet coming up?
The entry info says that it hasn't been certified. I don't know whether this is because the pool is too short, or if they just haven't bothered.
Jeff Roddin (the PV Top Ten Recorder) might know: you could ask him. You could also contact the meed director for more info.
