When I swim breaststroke, I use the outsweep and insweep type of pull. I don't focus on pulling back at all. I read it somewhere that you should also focus on pulling back. WHen I tried doing that, my hands got stuck and my timing is off. Anyone has any thoughts?
Also, how wide should you pull? I sweep out to 12-15 inches outside my shoulder width, anchor my hands, then start insweep? I am concerned it might be too wide. When I tried anchoring my hands narrower, I don't feel as powerful of an insweep.
Thanks.
Regarding lift,Bernoulles Principle is that as a fluid flows faster it's pressure decreases. An air plane wing is curved on top so the air has to travel further in the same time on top relative to underneath. Since it is moving faster the pressure is lower so the wing rises. Moving a hand through the water at an angle can cause the water on the back of the hand to move faster than over the palm so the hand will lift. The actual situation for a swimmer is much more complicated. There is a good article on this in the current issue of "American Swimming Magazine"
Regarding lift,Bernoulles Principle is that as a fluid flows faster it's pressure decreases. An air plane wing is curved on top so the air has to travel further in the same time on top relative to underneath. Since it is moving faster the pressure is lower so the wing rises. Moving a hand through the water at an angle can cause the water on the back of the hand to move faster than over the palm so the hand will lift. The actual situation for a swimmer is much more complicated. There is a good article on this in the current issue of "American Swimming Magazine"
